A simple break down.
A common question that we hear from SalesLogix users with Crystal Reports is how to setup parameters. A recent blog post from George Jensen gives a simple break down to accomplish this request. Below are a couple paragraphs from his blog:
"Recently I was asked to provide some help to a client on something
that is very simple and very easy to accomplish. I have covered this
same topic in a lot of my blogs posts but this very simple task is
buried in with a lot of other detail, so I thought it would be a good
time to just simply write about using parameters in Crystal Reports to
bring it out front and center for the reader to use.
The set up for this post is you have a report that you want to
choose whether or not to display certain
information when the document is run. In this instance we will use the
detail section of the report.
There are two items that work together to make this happen, a parameter and a formula."
You can read the blog in its entirety here.
-Brianna